Reverse Omosis Hi Flow 600 GPD System, Adjustable Flow Restrictor to 1:1 Ratio (Compact)
A manual flush valve allows you to clean the membrane, purging out pollutants that could otherwise add buildup to the system. Flushing adds considerable life to the membrane.
Membrane: One HF5-4014 600GPD TFC High Flow Membrane, industries highest flow membrane for maximum rejection 95-98.5% rejection.
1. Sediment Water Filter 5 Micron
1. Coconut Shell GAC Carbon Filter
1. Carbon Block Water Filter 5 Micron
1. HF5-600 Membrane (Installed into Stainless Steel Membrane Housing)
Includes adjustable flow restrictor. 2 - 10 " x 4.5" Housings - Pre Assembled on wall mount bracket
1" Inlet NPT for feed water connection. Auto Shut off Valve, Manual Flush Valve.
Membrane Flush Valve: For easy clean and considerable extension of membrane life.
Flow Restrictor : Adjustable for 1:1 Ratio
Recommended to adjust flow flow restrictor to 2:1 Waste to Good Water Ratio for better water quality.
Minimum 40 psi
Recommended Feed Pressure 80 psi - 100psi
Recovery (system ratio 1:1) 50%
Operating Temperature: 40F-105F
Operating pH : 3-11
Dimensions LxWxH (in) : 19x10x19
Nominal % Rejection:98%
Maximum TS:1200 ppm
Minimum NACL Rejection : 96%
Maximum Hardness : 15 gpg
Test Conditions: Permeate flow and salt rejection based on 250 ppm, 100 psi,
77F , pH 7, and 50% recovery.
Note: Higher TDS and/or lower temperatures will reduce the system's production. Membranes are tested at 85 PSI Water Pressure, 250 PPM and 77F Water Temperature. Lower Water Temperature, water pressure and higher TDS will reduce RO water production.
Feed Water Port 1" FPT
Warning: If you have very hard water, Use pre-scale removal filter is recommended. (Hardness not to exceed 15 gpg). Premature membrane fouling/scaling will occur if used with very hard water and very high PPM and above described water condition.
Adjust your flow restrictor when initially setting up and prior to use.